View Full Version : 4G63T Tech & Tuning
- Starion Intercooler Pipes???
- Opinions about forged pistons on a daily driver
- Fuel Pressure Regulator upgrade?
- Whats next?
- gauge hookup
- DSM virgin.... already getting my hands dirty.
- Get your stuff powder coated!
- VPC Tap
- Drilling heat shield for EGT probe
- How Loud?
- newbie
- Gvr4 trans
- Big Turbo?
- An external WG bypasses the o2 sensor
- Turbo vs NT motor mounts
- guestion on idle stuff
- Is a VPC reliable?
- Ringing MAS
- Just did 2 1/2" DP and HF cat to 3" catback, not much difference?
- Some REAL headlamp info...
- ECU questions: please help me
- To Disconnect or Not Disconnect...That Is The Question...
- Rewire mod?
- Balance Shaft Seal?
- Charcoal Canister to Intake...
- no boost
- fuel filter
- plug diagnosis
- keys
- Best way to install K&N filter
- Thrust bearing failure...
- Power Door Locks
- 1.8L N/A Power?
- what size FMIC will fit?
- Timing belt numbers
- dsm93talon: Purely Sublime?
- which turbo
- Compression check
- Knock Sensor LED on 2G
- Is a bigger FMIC neccessarily better?
- T.R.E FRANK 3 internal wastgate setup 34 mm flapper
- walbro louder + O2's lower = fuel filter!
- 60,000 Maintence?
- found something out..now confused..
- remove Heatsheld
- Apex'i N-1 Exhaust Pics!!!
- 1998 Talon Stock Wheel Specs
- bad or good condition turbo?
- Jap-Spec engine
- lifters from hell.....
- Timing Belt Change
- 95 Eagle Talon
- injector size
- Crate Motors?
- Trans oil help
- What are those electronic module things on the interior wall?
- apexi avcd how do i hook it up
- how large is the stock 2g NT throttle body?
- Brakes!!
- MSD DIS 2 needed for 11's?
- Car Codes
- 1g knock sensor
- How Many Of Your Rebuild Your Own Engines?
- 16g fuel upgrades, please help!
- what to use?
- Oil Pan Gasket
- Boston/Prov?
- timing belt tensioner tool/ re-time belt?
- What to check on used turbo?
- pipes: mandrel vs. pressbent
- neat trick
- how much torque?
- Do I need a Boost Controller?
- Thermal R&D installation
- Engine Oil
- TACH hookup
- Equal Length Halfshafts???
- Cyclone intake
- Need Help on my modifications...
- Mitsubishi vs Hyundai --> ? twins ?
- Best price on complete axes for 1G?
- More ? from the Newbie
- OEM part #'s
- removing the front clip
- Any cheap way to get traction?
- 1G BOV on 2G???
- best place to run wires through firewall
- Damn Wheel studs
- How much boost?
- Which walbro fuel pump?
- EVERYONE READ THIS AND POST WHAT YOU KNOW!
- Cost of new T-Belt, Water pump, and the rest??
- For those with notchiness or grinding while shifting....(kinda long)
- 3" Thermal R&D Vs. A'pexi N-1
- The new guy
- 2g Exhaust Manifold on 1G
- Fuel Pump Question
- Fuel cut at half throttle
- Ground Strap on DP? Location?
- Which AWD's came with an LSD?
- Non turbo motor....
- Is MCCC still availible?>>
- 8000 rpms or 9000 rpms
- oil from man. cover
- WHEELS
- When do you shift your 1g turbo when racing?
- What are the vents for on a 1G?
- engines
- hard intake pide mod?
- smog checks
- LIGHT'EM UP
- whats the noise im hearing?
- DOES ANY BODY KNOW THE ANSWER. HOW DO I HOOK UP MY APEX I A V C D A V C D
- Big 16G
- Laser RS-Turbo?
- Emissions and External Wastegates
- exhaust bolts
- Valve Cover?
- engine rebuild
- gauge pillar?
- How much do you think for.......
- Internal Leak. (long)
- Turbo effeciency
- Quick FSTB question>>
- crappy acceleration when cold
- who has the lowest prices on greddy fmic's?
- Joe P Boost Controller
- no heat!
- intercooler questions
- Rear strut bar
- Thermal R&D catback help
- N/T QUESTION
- HELP: Will Talon ECU work in GALANT VR-4?
- NE1 tried out this shifter Mod?
- faster spoolup
- What Kind of Oil Should I Use?
- 8.5 , 9.0, 10 : 1 ??
- The ticking has stop...for now
- Homemade 1G intake
- what RPM shift gives best milege?
- 1g MAF to 2g MAF
- Power button on AT (PART 2) :)
- Transmission number?
- Need new clutch & flywheel, which one?
- EGT temps...
- 90 fwd turbo
- 20G on the highway. Take out LS1??
- Team Rip
- ZEX Nitrous
- egt probe question
- Possible Clutch Slip? please help
- opinions on AutoLock?
- Timing Belt costly :(
- SAVE MONEY< ANY HELP
- RPM jump
- Twin turbo for the 4g63
- When or should I even switch to synthetic tranny fluid!!!
- dump tube mod
- homemade boost control
- best of the best for us turbo MT folks....
- BOV noise?
- K&N BREATHER FILTER
- what kind of cold air intake should i get?
- 7 bolt crank& A/T
- Does anyone know anything about Archer Racing turbos!!!
- Head question?
- who knows about potential of N/A 4g63
- 02 sensor
- Modifying boost levels
- Need help choosing an A/F gauge
- Can ACT2100 hold FWD power
- LSD question
- Team RIP tranny rebuild?
- bcs mod
- Very interesting Gas Mileage theory
- How much would you pay for LSD
- How much transmission fluid?
- Clutch change question
- modifying a small 16G
- Awesome new performance part store
- Alcohol injection
- anyone run 9:1+ comp in their turbo car?
- Cutting the Bumper Reinforcement???
- short shift kits for 95-99
- valves bent...head upgrades?
- HKS Upper Intercooler Pipe
- 2G front bumpers
- where is my dataloggin connector
- Front oil Seals
- Dyno Results
- New Toys installed! Need some input!
- Ahhhhhhhhhhh!!!!
- vacume gauge readings
- Rotors?
- FMIC + BOTH stock foglights: It can be done, right?
- Where is your EGT probe
- Injectors. RC vs. ND
- EGR blockoff for 2G ?
- psi for stock turbo?
- Please Help! Fuel Pressure settings
- help!
- A porting question.....
- Brake Accessories: Where's the Best Price?
- where do you put the Windshield fluid ?
- compare EGT temperature
- head rebuild parts
- Best place to buy a ACT 2100 clutch and what would be the price..
- injectors...???
- What do you'll think about these tires!!!
- What clutch to get?
- AFC tuning
- oil in intake manifold?
- Brakes
- post anyway you know of to get rid of wheelhop!
- 14B vs 16G (big or small)
- fuel cut and EBC?
- Help in regards with gauges
- Ram air mod
- boost gauges
- ECU Cabling
- Slap on a big turbo... but why?
- upgrades
- Boost Creep
- HRC Super 16G
- 97 engine in a 95 car.
- what is an afc and fmic and what do they do?
- Race VS Street gas
- Stand alone computers
- Hoggin' The T25
- T25 boost pressure
- Inspecting a FMIC
- forged pistons
- Transfer Case?
- Possible Engine Damage?
- auto times?
- TRans in a 91 Eagel Talon TSI
- Is this normal?
- Concerning Membership
- different engines?
- 2.5" or 3" catback?
- check engine light
- 1st gen NT and turbo engine questions--
- S-AFC on 2G NT
- 1994=California Emissions?
- Turbo Back Exhaust
- b&m shifter prices
- Sparko plug wires.
- Interior Lighting
- 3" abs homemade intake pipe installed, but have a ????
- External Wastegates and Smog
vBulletin v3.5.4, Copyright ©2000-2012, Jelsoft Enterprises Ltd.