2g NT Energy Suspension Motor Mount Inserts???

[VxROxV]

Has anyone ever purchased and installed these inserts from ENERGY SUSPENSION?! Any suggestions??? how hard was it??? I have no instructions so any help will be good... I also looked at the RRE site and instructions but those are for a 2gTURBO... is there a difference?! Please help!!!!

thanks
RO

[TechT]

The motor mounts shold be the same.I'm a previous owner of a 97 GS.There are 2 bolts that hold the mount to the car and 1 bolt through the bushing.What you want to do is:
1.jack up car and use jack stands.....***SAFETY FIRST***
2.unbolt the 2 bolts holding the mount to the car
3.use another jack and jack up the engine **JUST A LITTLE BIT** if you go to far your going to bend something
4.unbolt the bolt going through the bushing and pull it out
5.wiggle the mount off the car.you'll see once it's lose
6.insert the inserts and put the big washers on the out side
7.install in reverse order(i put the 2 bolts holding the mount to the car first)

it took me maybe 20 min or so to due the front motor mount on my fiends car.

[VxROxV]

THanks for the step by step instructions... That would really help alot... another question, where should i jack up the engine?! is there anything i need to use for support in jacking up the engine?! also the install, the 2 washers, do they go in the front mount or the rear?! Also, those instructions you gave me will work for both the front/rear right, or just the front?!

Thanks ALOT!
RO

[95ESi]

Do anyone know if there are any motor mount inserts for 2GNT automatics?

OR are they the same...

[JD 95 GS n/t]

another question, where should i jack up the engine?! is there anything i need to use for support in jacking up the engine?! also the install, the 2 washers, do they go in the front mount or the rear?! Also, those instructions you gave me will work for both the front/rear right, or just the front?

place the jack on the oil pan but use a block of wood
the 2 washers are for the front
the rear is not the same as the front you have to unbolt the trany and is not fun. 3 bolts go in to the trany and one through the mount

I have a master kit for sale for like $175 it`s a full kit
all bushing and motor mounts
e-mail me

[LaFemmeDSM]

It's been awhile so bear with me. I'm not sure if it is the front or back that gets the washers but I do remember they go on the one that was thinner.
Sorry about being so blunt it's been over a year since we installed them.